November 19, 2015

Just released Pyramid PB3818 5,000-Watt

On Sale Today:




Pyramid PB3818 5,000-Watt 2-Channel Bridgeable Mosfet Amplifier price and review:
  • Two Channel Amplification – Soft Turn On/Off Circuit – Remote Turn On – Power and Protection LED’s – Dimensions: 10.24”W 2.26”H 13.78”L
  • 1 5000W Watts 2 Bridged – Bridgeable into 4 Ohms – Hi/Low Level Inputs – Frequency Response: 15Hz-30KHz
  • 2 2500W Max Output – 2 Ohm Stereo Stable – Heavy Duty Aluminum Alloy Heat-sink – S/N Ratio: >95DB
  • Fully Adjustable Electronic Crossovers – Mosfet PWM Power Supplies – High Impedance Input – THD<0.04
  • Variable Bass Boost (0-12DB 50Hz) – Variable Gain Control – High Level Molex Input – Fully Protected Circuitry

Warranty: standard manufacturer’s warranty
S&H: Free shipping if ordered online
Pyramid PB3818’s dimensions and weight: check our reviews
Sale-end date: check our ratings
PB3818 best price: see above

General Pyramid PB3818 description
This 2-channel Pyramid America amp is all you need to blast your music to new levels of American excess. No one does booming, ear-thrashing bass and sweet, mind-tweaking highs like Americans, so take your sound to the next level with this amp. It provides up to 2500 watts of pure patriotic power & 8211; or bridge this amp to one channel and push it to 5000 flag-waving watts And you don& 8217;t need to worry about overheating & 8211; the entire thing is a heatsink. It& 8217;s equipped with a fully adjustable electronic crossovers for a multi-speaker setup, variable bass boost and gain control. Power and protection LEDs assure you your equipment is safe. Takes both high and low level inputs. THD < 0.04 .


Comments about pricing:

Ok like most ppl in the reviews befor me I to was disappointed. I have to 12 inch Impp subs in my car that I use to have hooked up to my west coast custom 800 wat amp. When I saw the 5000 wat amp here and for the cheep price it had, I figured it’ll be better than the amp I have now either way it goes, so I ordered it. I just received it today ( may,11,2012 ) and I wired it up using the 3000 wat amp wire kit that I was using with my old amp, and when I cut it on and turnd it up it was a lot louder but the bass was hiting just a lil bit lower then the 800 wat amp I had. So I was like darn I should of took the advice from the reviews and not order it. Then right as I was in my lil slum mood. I started to read the holders manual that came with the amp. In it, it tells you step by step on how to wire the amp to your liking. And I like lots of bass So I read were it said to hook up the bass to “mono subwoofer mode” were I wire up my speaker wire to the 3 and 4 channel, then I tryed it again and all I can say is woooowwww Its hiting way way harder then my old amp, I had everyone on my block coming outside and looking around. I say its a great purchase for its price and I am happy with it till I feel the have to upgrade more$.



This high quality PB3818 image should describe it from all the angles

Should you buy it:

Heard that it was a cheap brand but decided to go with it for the price. When i got it i was like this peice of.. Isn’t 2000 watts. Its really small. My 12 inch sub is bigger than this. And it only has a 30 amp fuse. But once i hooked it up it really surprised me. It had my subs hitting and was only halfway up with the bass increase at zero. Ive had it on now for only like 2 weeks and it still sounds great. I liked and its still working so far so ill c how long it last. If it messes up soon my review will change. UPDATE Just back to say that it lasted me 8 months with bumping everyday for more then an hour, never overheated, however decided to sell it for a whole car upgrade. It was nice while I had it. Never had problems with it. But now im going with 2 soundstream twelves, soundstream turantula tx1. 2000d, and a soundstream px4. 580. Big upgrade..



Sometimes it takes up to 1 hour to find out how to use 2-Channel perfectly, but it's totally worth it

Is it worth the cost:

Had amp installed. Installer said amp was dead. Got second opinion trouble shoot amp and WoW. With 2 MTX thunders and JVC arsenal deck plus a 2 channel Cerwin Vega and a power acoustik graphic eq my speakers scream and pounds hard you may be able to hear me beating down the block like King Kong. Only put volume on 10 and it beats like its on 29. I could recommend this amp for anybody ballin on a budget AND wants good sound .


High res images of 5,000-Watt's are preferable if you include the full name
General Car Electronics review related to Pyramid PB3818

But it’s more common in aftermarket that visual aesthetics take on a more important role in design than other types of sub drivers, as well as high contrast paint schemes, grill covers, translucent or refractive materials. A subwoofer can be used when present low frequency production is unsatisfactory, either in frequency range or in volume. Subwoofers can also be found in mobile audio applications where a cabin speaker may lack the wanted low frequency answer on own. In the case of subwoofers, mountings are typically under the seat or in the trunk. In older vehicles that had audio parts as an choice, such devices were mounted externally to the top of or underneath the dash. Amplifiers rated at 100 watts at 14. Other possible parts include different media devices, like (in older vehicles) a tape player (either 8-track or cassette), CD player, DVD player, HD Radio, Satellite Radio, USB flash memory, and a movable hard disk drive usually used in notebook computing. Design objectives have led to subwoofer, both drivers alone and whole packages, with some extreme difference from one another. Throughout operation, it’s common for a car’s charging system to change, so a regulated amplifier will maintain its power output despite of voltage fluctuation. Although less common, OEM external amplification may be found in ‘premium’ audio packages, or in luxury cars. Subwoofers are a particular kind of loudspeaker for low frequency reproduction. Cassette decks have been found in cars as late as the 2008 Acura TL, and in the 2010s the CD player is still a regular part of most car stereos, though their non-car counterparts (i. These cutouts, but, also allowed for easy theft of the car radio. The common parts are a radio receiver/tuner typically with AM and FM bands, and a small amplifier for driving an audio signal to speakers. ” A Chrysler designer had an opposing view, saying “The center stack is such precious real estate it is like the waterfront in Chicago. Car stereos usually lag behind audio technology. Stock systems may be minimalist and basic or complete, based on the intention of the car maker. For decades most car dashboards had a rectangular “cutout” where the head unit was installed (which went above another rectangular cutout for the HVAC controls), and this allowed for straightforward substitute of the stock system with an aftermarket stereo, since audio technology improves faster than model updates from car businesses. In most modern applications, speakers are mounted certain common places as well as the bottom of the doors, the front deck (or dash), the rear deck (or parcel counter), and the kick panel (located in the footwell below the A-pillar).



Compare Pyramid PB3818 5,000-Watt with similar products and prices:

HP f800x FullHD 1080p Car Dash Cam 140Degree GPS Advance Driver Assistance Motion & Collision Detection & WDR

  • Frequency Response: 20Hz-20kHz (+0dB, -1dB)
  • Enter your model number above to make sure this fits.
  • Signal to Noise Ratio: 90dB (Reference: Rated Power into 4Ohms at 14.4V)
  • Approximate Dimensions: Height: 1.75″ Width: 5.69″ Depth: 3.88″

Polk Audio DB5251 5.25-Inch 2-Way Component System Single Silver

  • Fully Adjustable Electronic Crossovers – Mosfet PWM Power Supplies – High Impedance Input – THD<0.04
  • Variable Bass Boost (0-12DB 50Hz) – Variable Gain Control – High Level Molex Input – Fully Protected Circuitry
  • 2 1500W Max Output – 2 Ohm Stereo Stable – Heavy Duty Aluminum Alloy Heat-sink – S/N Ratio: >95DB
  • 1 3000W Watts 2 Bridged – Bridgeable into 4 Ohms – Hi/Low Level Inputs – Frequency Response: 15Hz-30KHz
  • Two Channel Amplification – Soft Turn On/Off Circuit – Remote Turn On – Power and Protection LED’s – Dimensions: 10.24”W 2.26”H 11.02”L

Icom IC-A14 VHF Air Band transceiver

  • Frequency Response: 20Hz-20kHz (+0dB, -1dB)
  • Enter your model number above to make sure this fits.
  • Signal to Noise Ratio: 90dB (Reference: Rated Power into 4Ohms at 14.4V)
  • Approximate Dimensions: Height: 1.75″ Width: 5.69″ Depth: 3.88″

Lanzar VIBE442N Vibe 5000 Watt 4-Channel MOSFET Amplifier

  • 2 x 350W RMS 2 OHMS – High Pass Filter Controls – Freq. Response: 20Hz 40KHz – Dimensions: 1.24”H x 4.46”W x 4.63”D
  • 2 x 500W MAX 4 OHMS – Nickel Plated RCA Inputs – THD:90dB – LPF Freq. Response: 50 500Hz
  • 1 x 1000W Max 4 OHMS Bridged – Low Pass Filter Controls – Channel Separation:>65dB – Fuse: 30A x 1
  • 2 x 250W RMS 4 OHMS – Bridgeable at 4 Ohms – Soft Turn-on/Turn-off – HPF Freq. Response: 50 500Hz
  • 2 Ohm Stereo Stable – Power and Protection LED Indicators – Electronic Crossover Network
  • Two Channel Amplification – Soft Turn On/Off Circuit – Remote Turn On – Power and Protection LED’s – Dimensions: 10.24”W 2.26”H 13.78”L
  • 1 5000W Watts 2 Bridged – Bridgeable into 4 Ohms – Hi/Low Level Inputs – Frequency Response: 15Hz-30KHz
  • 2 2500W Max Output – 2 Ohm Stereo Stable – Heavy Duty Aluminum Alloy Heat-sink – S/N Ratio: >95DB
  • Fully Adjustable Electronic Crossovers – Mosfet PWM Power Supplies – High Impedance Input – THD<0.04
  • Variable Bass Boost (0-12DB 50Hz) – Variable Gain Control – High Level Molex Input – Fully Protected Circuitry


ADAPTIV TECHNOLOGIES TPX RADAR LASER DETECTOR SYSTEM 2.0

  • Low and High Level Inputs
  • Variable Bass Boost
  • Variable Crossover
  • Full-Range, Class A/B Topology

Speaker 15 Peavey Widow 8 Ohm 1505-8 DT BW

  • Frequency response: 15 Hz-30K Hz
  • Thermal / overload / short circuit protection
  • 3000W x 2 output at 4 Ohms
  • Signal to noise ratio: >95dB
  • 6000W x 1 bridged output at 2 Ohms 2 Ohm Stable
  • Please find the user manual in the technical specification section


Related 5,000-Watt 2-Channel PB3818’s Comments and coupons:
I had been looking at them for years and felt that the time was right for the performance and pricing that was available. Even thought I will never find a coupon for a 4 X New MM651UM, I stil intend to buy one for my wife as she is worth the price. If you compare the price of this product to other stores I think we offer the best deal.

2-Channel 5,000-Watt Bridgeable technical ratings and MSRP
  • 2 2500W Max Output – 2 Ohm Stereo Stable – Heavy Duty Aluminum Alloy Heat-sink – S/N Ratio: >95DB
  • Two Channel Amplification – Soft Turn On/Off Circuit – Remote Turn On – Power and Protection LED’s – Dimensions: 10.24”W 2.26”H 13.78”L
  • Variable Bass Boost (0-12DB 50Hz) – Variable Gain Control – High Level Molex Input – Fully Protected Circuitry
  • 1 5000W Watts 2 Bridged – Bridgeable into 4 Ohms – Hi/Low Level Inputs – Frequency Response: 15Hz-30KHz
  • Fully Adjustable Electronic Crossovers – Mosfet PWM Power Supplies – High Impedance Input – THD<0.04

Walmart For Sale at Costco Ebay purchase
Amazon Reviewed at Craigslist Best Buy
Target Home Depot Lowes
Sears coupon


Select cities



What people considered before buying it:
  1. PAIR BOSS AUDIO P126DVC Phantom 12″ 4600W Car Power Subwoofers
  2. BOSS Audio KIT2 8 Gauge Amplifier Installation Kit
  3. 0 Gauge Amp Kit Amplifier Install Wiring 1/0 Ga Pro Installation Cables 5000W
  4. Earthquake Sound AK-5000 Complete Amplifier Installation Kit
  5. BOSS Audio P156DVC Phantom 15-inch 2500-watt DUAL Voice Coil Subwoofer
  6. PYLE PLCHW15 15-Inch 3600 Watt DVC Subwoofer